Using Shelly 3EM with three phase source

    • Autor

    Dear Shelly Community,

    I've searched the forum and web extensively but haven't found a solution to my Shelly 3EM issue.

    Setup:

    • Shelly 3EM installed on a three-phase source powering a three-phase motor.
    • Shelly reports line-to-neutral voltages but not phase-to-phase (RY, YB, BR).
    • Wattage readings differ from clamp meter measurements.

    Query:

    1. Can Shelly 3EM display phase-to-phase voltages (RY, YB, BR)?
    2. Would displaying phase-to-phase voltages resolve the wattage discrepancy?

    Thank you for your assistance.

    Sincerely,

    Museec

    Welcome to the forum!

    Zitat von museec

    Can Shelly 3EM display phase-to-phase voltages (RY, YB, BR)?

    No. This is the first time somebody asked this!

    Zitat von museec

    Would displaying phase-to-phase voltages resolve the wattage discrepancy?

    No. This issue (netting of energy) has to be solved with a higher level home automation system.

    „Habt Geduld. Alle Dinge sind schwierig, bevor sie einfach werden!“ (aus Frankreich)

    „Nothing in life is to be feared, it is only to be understood.“ (Marie Curie, 1867-1934)

    „Comment is free, but facts are sacred“ (C.P. Scott, britischer Verleger)

    • Autor

    Dear Mr./Ms. Thgoebel,

    Thank you for your response and taking the time to assist me.

    After further consideration, I believe this unit might not be the best fit for my specific needs.


    Thank you again for your help.


    Sincerely,

    Museec