Hello,
I want to use Shelly1 with Wifi AP mode, but i can't setup the i/o url...
I'm tired this urls (on button long pressed url):
- http://localhost/relay/0?turn=on&timer=300
- http://192.168.33.1/relay/0?turn=on&timer=300
but unfortunately it doesn't work.
Any solution? 
Thanks.
It is not possible to send http: commands at the own address of a Shelly in AP mode with /localhost! You’ll need a second Shelly to span an AP cell (192.168.33.1). After that you should include the Shelly to be controlled via http: command in this WLAN. Usually, the second Shelly will get IP address 192.168.33.2. With this Shelly you may send http: commands with /localhost identifier.
Another question: Do you urgently need sending http: commands from detached input to Shelly‘s own address?
And yes: You may join the Shelly to the AP (hotspot) of your cell phone.
But would a second Shelly not be applicable?
Another question: Do you urgently need sending http: commands from detached input to Shelly‘s own address?
I'm using "Momentary" button type and I need long press mode for more timer. (Although not so important.)
ZitatAnd yes: You may join the Shelly to the AP (hotspot) of your cell phone.
👌
ZitatBut would a second Shelly not be applicable?
I don’t shy away from it, now I’m learning to use shelly just to ask.
