VPN/Proxy erkannt
Es scheint, dass Sie einen VPN- oder Proxy-Dienst verwenden. Bitte beachten Sie, dass die Nutzung eines solchen Dienstes die Funktionalität dieser Webseite einschränken kann.
-
I’ve purchase Two ‘Dimmer Gen3’ modules to control lights on two different circuits so they come on together when triggered by PIR on either Dimmer ‘S1’ terminal.
The PIRs in:
OFF state are at ‘161.5V 0hz’
ON state at ‘240V 50hz’
Ideally I want to have the following setup:
Light ON dimmed to 50% brightness 1hour after sunset until 11:30pm.
After sunset and before sunrise if PIR ON (time delay on PIR) light goes to full brightness until PIR ‘OFF’ dims to 50% if before 11:30 OR OFF if between 11:30 and sunrise.
There are PIRs on both Dimmers. When one operates it should tell the other to do the same.
Is this possible? Just getting it to operate with the PIR would be a start!
Thanks
Dave
-
I've looked back through the treads but I can't find any information on dimming the same lamps from multiple locations on intermediate or 2way switches. Is this possible and if so what modules would I need to achieve please?
I'm using retractive switches, which are compatible with the shelly dimmers. The circuit has the switch line, line and 2 way cables in one location, intermediate switches in 2 further locations and a final location with 2 way switches presently. These 4 locations all control the lights. If I was to install retractive 2way light switches in all 4 locations would I be able to use Shelly Dimmers in all 4 locations to dim the lights in each independently of one another OR as in a conventional lighting setup is this solely possible at the first location with the switch line.
Many thanks in advance. Dave