Beiträge von aabafra

Any diagram that I could use to have an idea on how to mount it? Also have a 3 way switch and I would like to control it with Shelly and even have the possibility to dim the lights. I haven’t fount it, the official ones are for 2 way switchs or the typical physical dimmer as a wheel

Thanks 66er for your quick response.

Obstacles detection is disabled and security interruptor is disabled by default as I don't use a single button input.

I just have enabled max power protection at 1840W. I've just checked to disable it and it's still happening the same, it just ignored the position that I want and keeps progressing to the end (and the position marker in the app too, going from 100% to 0% no matter what I choose).

Don't have a clue on what to do.. to be honest..

Thanks

Antonio

Hi,

I have the same 4W problem as my shuther is contrable through both a telecontroller and a pushbutton and therefore has a low voltage receiver.

Firstly, I tried the light bulbs trick but was having problems with it (don't know why). Then I realized that I have another shutter with the same size as the problematic one (same travel times) but without the telecontroller low voltage receiver so I connected Shelly to this one to calibrate it.

I suceeded on it and the shutter started to show the positioning bar, but when I put my Shelly 2.5 again in the problematic one, it wasn't able to position the shutter in the position I want. For instance, If the shutter is up, and I put it at 50%, it starts goind down and suddenly the cursor goes to 0% and the shutter closes completely. Same doing the opposite from down to up not being able to stay at the position I want.

I was wondering if it needs more than 4W power not only in the calibration process, but also during its regular working.

Thanks in advance.

Antonio