Thank you for your input!
I think I know enough to get some measurements going and feed the data into my home assistant.
On a sidenote, I have been looking into the EM instead of the 3EM, but the availability seems to be an issue. I will find a use for the third clamp f.e. measuring a circuit where some older appliances are present might be insightful.
Thanks again!
Hello thgoebel
Thanks you for your welcome and very quick response.
Is my assumption correct that for each clamp (IA,IB,IC) I need one live wire into a V-port?
So if I only use 1 clamp on IA I need to put one cable in VA?
If i were to put it behind an existing breaker in my board, would this be a correct wiring (without a clamp for the solar array)
The live wire from the breaker to VA
The neutral wire from the breaker to N
A clamp on the black wire (not sure about this?) to IA
To add a measurement for solar:
wago on live wire and add a cable to VB?
Clamp from IB to live wire of the solar array, direction inverter -> breaker for the solar array?
Thanks in advance and sorry for the many questions 
Hello everyone
I am currently looking into the Shelly options to monitor my energy consumption.
I was wondering whether or not the Shelly 3EM is an option in my situation, which (I think) is comparable to the situation mentioned in this topic but I did not want to hijack that topic.
Incoming:
My board mentions 2x230v, this has no neutral (I always thought the blue cable was supposed to be neutral)
I wanted to have a power measurement of the consumption while taking into account the production of my solar array.
I know the 3EM is focuses on multiple phases but this diagram seems to be the situation I am in.
Is this something that the Shelly 3EM (or EM) supports?
Thanks in advance!
Some visuals:
cable connection after the (analog) consumption meter:
Main breaker:
Incoming my electrical board, main differential:
Bridge at my main differential:
