Please have a look at the sketch:
Der Inhalt kann nicht angezeigt werden, da Sie keine Berechtigung haben, diesen Inhalt zu sehen. In the case your not familiar with diagrams, try to get help from a friend with skills in electronics or electrical work!
Hello thgoebel,
Thanks again for your help.
I just wanted to tell you that I have now installed and automated them in Homeassistant and it works perfectly!
This helps! Thanks you so much for your time to draw this for me.
Welcome to the forum!
Use two Shelly pro 2. These provide two dry contacts each. HomeAssistant shall provide that one contact is closed at one time only. Obviously, the closing of two contacts does no harm to the pump but interferes correct operation only.
In the meantime, I have looked at the Shelly Pro 2 further, but I do not understand how to connect the wiring. As already mentioned, I'm not much of an electricity technician and it must sound stupid, but can anyone tell me how to connect it? Thank you in advance!
Thanks for your reply!
I had hoped that I could install 1 or 2 shelly's in a junction box.
But if that is not possible, this is also a nice solution!
Hello all,
I am not a seasoned technician and therefore have a question which shelly I can use.
The circulation pump of my swimming pool has the possibility to control it digitally
It comes with a 5 wire cable so I can run my pump in 3 different modes.
Does anyone know which Shelly I can use for this?
I'm using HomeAssistant to control it (finally)
See attachment for the wiring.
