Beiträge von TobiSmartHome

It seems even with the latest firmware this issue persists. The only option I found was to add an automation for the second switch. It works, but this is not as I would have expected it.

Zitat von thgoebel

I suppose the map input selection is reachable in the the WebUI! Unfortunately, I have actually no Shelly pro 1 to check this…

Ah, just learned that between the Shelly Cloud and the App there is also the WebUI. That is a bit confusing, as they are not all showing the same, but indeed the config there allows to select Input 0 or Input 1, which respectively selects either SW1 or SW2. How should a user know this from the documentation and when will there be a stable version reflecting the wiring scheme in the manual?

As promised, here I am again. So as @Olsche points out, I tried to use the wiring scheme as described at https://shelly.cloud/knowledge-base…b_6314ea1971bd8 and expected SW1 and SW2 to at least do the same, or even better be configurable to do something else. However I understand that there is a bug in 0.11.0 and currently only SW1 is used, SW2 is dead, right? As this is a bug, what is the planned function in the final version?

And then where can I find the Map input configuration shown in your screenshot? Here in my app I can select between button and switch, where I need to select button, because I have a momentary contact which otherwise cannot be configured (see the grayed out items). Where can I find the Map input selection?

Hey thgoebel and @Olsche I think the issue described by @Olsche is the problem I am seeing, but if I remember correctly my App shows Button/Switch not input 1 or input 2.

I will check that later when I am back home and update this thread with another answer.

Hi there,

I started my smart home journey with Shelly and recently ordered a Shelly Pro 1. After installing it, I configured it to replace my old relay and it works as expected, except for one detail. I have multiple momentary buttons in my hallway and the Shelly only reacts on those connected to SW1, but not to SW2. I changed the cables, which makes the other half of switches working, but kills the other half. I couldn‘t find any setting that could influence this in the App, only a firmware update, which I did, but it changed nothing.

Is there anything else I can test or check or is the Shelly Pro 1 defective?

One other question: The Shelly sits relatively loose on the DIN rail, is this by design?

Thanks for your support, if you need anything else, to support me, please let me know!