I have a new house where I need to mount and test 50 shellys
But the Wifi system is completely poor (just 1 telecom router with Wifi)
We will be upgrading Wifi in approximately 2 months with a couple of AP all around the house
But meanwhile I need to setup and test these 50 shellys I've mounted.
My idea is to install and configure those 50 shellys with the natural process. However after installed, I would like to "deactivate them" or leave them in "standby" or something like that, so they do not saturate the wifi network, so I would only have 5 active shellys at any given time, but I could reactivate them all as soon as I have all the Wifi mesh mounted (same AP name and password)
WARNING! In case the device has not created its own AP Wi-Fi network with SSID like ShellyPlus1-f008d1d8bd68, please check if the device is connected according to the Installation Instructions. If you still do not see an active Wi-Fi network with SSID like ShellyPlus1-f008d1d8bd68, or you want to add the device to another Wi-Fi network, reset the device. If the device has been powered on, you have to restart it by powering it off and then again on. After that you have one minute to press 5 consecutive times the button/switch connected to the SW terminal. You should hear the relay trigger itself. After the trigger sound, Shelly Plus 1 will return to AP mode. If not, please repeat or contact our customer support at support@shelly.cloud .
The thing here is that I'm using Shelly 1 Plus for multiple dry contact devices, so I'm not connecting anything to SW, just I-O and L-N this way:
Inhalte von externen Seiten werden ohne Ihre Zustimmung nicht automatisch geladen und angezeigt.
But I power off and on the devices and I can't see the AP.
I've put a multimeter in the white and red cables (connected to AC, by the way regardless of the color code), and they show the 220V, so Shelly is receiving power.
What shall I do if I don't use the SW switch to see the AP?
PS: Bluetooth is not shown either when trying to pair via Android Shelly app.
