Beiträge von dipling

Zitat

If you don't want the motion to be active, you have to deactivate the SW input with an action command (Detached) and reactivate it vice versa.

This could work. I believe I can only set both switches to detached mode, which means the whole ON/OFF control must be handled externall, in homeassistant.

Thanks

Hi

I want to user a Shelly dimmer 2 to control the entrance outdoor lights as follows:

• SW1: a motion sensor shall automatically switch on/off the light when motion detected
• SW2: the wall switch shall work as follows:
  • when OFF: motion sensor controled lighting
  • when ON: light always ON

Is this behavior possible with the available dimmer 2 firmware? Can the switches be independently configured?