Button Type should be set to „Edge“!
Thank you
Beiträge von Affelectrical
-
-
Your wiring is correct. Assuming, both switches are working, the installation should work. A similar diagram is available in forum‘s lexicon section:
Only the wiring of the two switches is slightly different - but this not really relevant. Please have a look at the information box in the above diagram!
Do I need to change anything on the shelly app on my phone? In button type etc?
-
I can't see any error. the question of the button type remains.
and since this is now a test setup. does it work there?
This still isnt working sadly. Any help would be appreciated.
Question what is sw2 output for on the shelly? For a 2 way switch does this need to be used as well?
-
I can't see any error. the question of the button type remains.
and since this is now a test setup. does it work there?
No it is not working. Only switches from each switch rather than a traditional 2 way switch. I will check the normally open open / normally closed but I assumed every 2 way switch worked that way
-
seems to be the wrong button type for me Which one is set?
I mean it dims up and down through the app
-
Der Inhalt kann nicht angezeigt werden, da Sie keine Berechtigung haben, diesen Inhalt zu sehen. Hopefully you can make that out
-
I'll draw it out later today. Thanks
-
this is the set up
Der Inhalt kann nicht angezeigt werden, da Sie keine Berechtigung haben, diesen Inhalt zu sehen. -
they are just standard BG 2 way switches. I'm now bench testing it at home. How do I attach a picture?
-
Hello. Im a scottish based electrician and a client has purchased these shelly 2 dimmers. I have wired as above but the "2way switching" does not work. If I turn it on from say switch A I can only turn it off from switch A and not switch B and vice versa. I can control via the app online and can see it connected to my phone, it dims up and down but I cannot get the 2 way switching to work. Any help would be very much appreciated
