Beiträge von dedepene

This is the product page on the manufacturer's website - https://www.autotech.gr/product/s5060/

I clearly need a 2.5 as the motor has two phases - one for opening and one for closing.

EDIT: Aha! Now after you mentioned it, I realize I can wire the shelly 1 to the "button" (NO) terminals on the board. This route is what you had in mind suggesting the one instead of a 2.5, right?

Hi!

A little help with wiring a 2.5 to control a sliding gate please? Crucially I need to keep the functionality of the hardware endstop (limit) switch. So how do I wire the Shelly in a roller mode where it keeps track of positions and everything?

It's a RF433 controlled board and a remote that operates like so: start-stop-close-stop

Here's pretty much the same thing, but with some dip switch options for the board:

https://www.autotech.gr/wp-content/uploads/2017/08/S5060.pdf

Many thanks!!!

but 1.1.10 < 1.5.10 ...no? And I already tried with 1.1.10 without any luck....

Zitat von 66er

Try to update on a lower firmware first.

There is no lower than 1.1.10 ...is there?

btw, can you please confirm that shelly plug model S171 (the device i have) corresponds to fw code shplg2-1?

I have the exact same problem with a couple of shelly plugs. I did try going back all the way to v1.1.10 with no luck. Seemingly the firmware is being installed, the device reboots, but it is inevitably stuck at 20170502-134728/master@3101efe1+

What's up with that?!