VPN/Proxy erkannt
Es scheint, dass Sie einen VPN- oder Proxy-Dienst verwenden. Bitte beachten Sie, dass die Nutzung eines solchen Dienstes die Funktionalität dieser Webseite einschränken kann.
-
Is there a way to configure the Shelly Flood sensor to send regular reports?
I need to activate a pump when there is water and if the flood sensor has already reported flood it will not report again until the status changes. This means that if an update on status changing from dry to wet fails, it will sit quietly until the state changes - which it never will as the status in the cloud is still dry.
If I can configure the sensor to send regular reports then perhaps I can detect flood even if the flood status change has been missed.
-
I am trying to send DDD from a Shelly Flood Sensor to a ShellyPlug, but the ShellyPlug does not switch as expected
Shelly Flood sensor:
IP: 192.168.0.191
Command configured when rain is detected: http://192.168.0.179/relay/0?turn=on
Firmware: 20211109-125548/v1.11.7-g682a0db
Shelly plug
IP: 192.168.0.179
Firmware: 20211109-130223/v1.11.7-g682a0db
My test PC connects to both devices, the state of the plug changes when DDD is sent from browser but not when sent from the sensor. The sensor detects water and can control relays via a scene on Shelly Cloud.
When setting a DDD action on the sensor via Shelly Cloud the configuration change is confirmed but when going back to the same page the configuration has been lost.
There is an old post with similar problem solved by upgrading to v1.9.1. Has the issue returned? Does the clould actually change the setting? Does the sensor actually send any DDD?
