Beiträge von Erik Hoek

Zitat von thgoebel

Possibly, the RGBW2 is faulty…

Or a bug in the firmware. The input is set to detached mode so what ever happens on the hardware input, the software should ignore it for switching lights on and off but clearly the status log shows it reacted to an input.

I also tried to connect the input terminal to ground and to 12 VDC, but it still happens. The time after which it shuts itself off is also not consistent, sometimes it happens after only 10 seconds and other times it stays on for half an hour.

Zitat

Sorry,

i try to check, wether i'm wrong.

No problem!

This is how i have it set right now:

I have it in white mode yes. Where in the web interface can i set how it should react to the input seperatly for the four inputs then?

I can only set the button type under the main settings. Under the settings for each input seperately i can not set how the button/input should react.

Thanks for the answer!

When i give the http command it says "http", but after it turned off it says "source":"input". I had set the input to "Detached Switch" which as far as i understand it, should do nothing to 4 led outputs. Also there is nothing connected to the I terminal.

Hello,

I have an RGBW2 in white mode which at this moment i only control by sending http commands. This works as it should, but after a while (ranging from about 30 seconds to a few minutes) the lights go out without me giving a command to do so. I use the following command to turn the lights on:

http://192.168.178.143/white/0?turn=on&brightness=70
http://192.168.178.143/white/1?turn=on&brightness=70
http://192.168.178.143/white/2?turn=on&brightness=70
http://192.168.178.143/white/3?turn=on&brightness=70

I'm running the newest firmware (20211004-121740/v1.11.5-gdedfb52) and have not connected the module to the cloud, or any other controller. Is there perhaps a setting which could cause this?