Beiträge von MustRotate

    Der Inhalt kann nicht angezeigt werden, da Sie keine Berechtigung haben, diesen Inhalt zu sehen.

    This is how it looks like after I have added it in the app. But it doesnt react to switching on the thermostat. Means I have IP for it, I can add it in the Shelly app but it doesnt do anything. I have tried deleting it from the app and re-adding it, either via add device or via IP but same behavior.

    As it currently stands only thing which I didnt try is deleting the iOS Shelly app alltogether and reinstalling both the shelly 1 and the shelly i3 again.

    Hello,

    i have lost internet for 24h and now I cannot add anymore the i3 to the Shelly mobile app.

    Following steps are taken:

    - reset i3 via button on him

    - connect on mobile phone on the shelly ix3 AP

    - open browser on mobile phone on 192.168.33.1 and set the WIFI name and password. Get message that I can use the i3 with the new address

    - now go to the Shelly mobile app but here I cannot see the i3.

    Tried the steps using the mobile app and also the desktop app, same results.

    I had a dual setup, shelly 1 and shelly i3, one receiver and one receptor in order for the floor heating command control (i3) to control the heating boiler (1)

    Thank you in advance for your attention!

    So you think the i3 is triggering the command or the control central is saying to the i3 to close the circuit and it just does what it sees on the inputs?

    I'm trying to troubleshoot this as the central gas heater running without any request from the thermostats might not be that good.

    Hello all,

    i'm trying to connect a Shelly i3 to a Shelly 1 to be used in order to control the central gas heater of a floor heating system.

    i3 is connected to the control central of the floor heating system and when it closes a contact the i3 should signal this to the shelly 1.

    Shelly 1 is connected to the central gas heater(Immergas Victrix Tera) on the thermostat contacts.

    Basically the shelly i3 and the shelly1 should mimic themselves, when i3 senses that it its input is closed is should sent this to shelly1 which also should close thus telling the central gas heater that hot water has to be sent to the floor system.

    On the i3 i selected button type toggle switch and in the I/O URL action button switched on URL with http://192.168.0.129/relay/0?turn=toggle

    This works to turn on the heating(shelly1 turns on by closing its contacts 0 and 1) but when the i3 should open the shelly1 this doesnt happen. What am I doing wrong?

    Basically I am trying to replace the wires in the picture below(cut with red) with a wireless solution as the current cables are cut somewhere in the wall. Shelly1 is on the boiler, Shelly i3 is on this command central for the valves.

    Der Inhalt kann nicht angezeigt werden, da Sie keine Berechtigung haben, diesen Inhalt zu sehen.