the eQ-3 130366 Power On Current Limiter hasn't stopped my 1PM often crashing/rebooting when my 45w LED batton switches on.

I've ordered the eQ-3 one, saves finding a case for it like you say.

Will report back once it arrives from Germany and tested.

Zitat von thgoebel

Usually, LED lights (especially those with higher consumption as in this case) are tending to produce high inrush current - not voltage spikes. Thus, a R/C snubber will give no remedy! Would recommend to use an inrush current limiter like this:

https://www.amazon.de/dp/B00E92XZB6?…9Q48FE3SNTP2V4P

thanks for the quick reply.

would this product be suitable also?

https://www.ebay.co.uk/itm/1433703688…ar=442282673304

It seems to be one extreme to the other with these inrush devices.

Your linked one not so available in the uk.

Can i check something, I have a 1PM with a 45w LED Batton light in the garage.

It often crashes/reboots when the light comes on (causing the light to go off, which a planned reboot doesn't).

Should I I try a shelly RC Scrubber?

With the official wiring diagram and the comments above in this forum post.

Should the scrubber be directly screwed into the shelly terminals connecting O and N together?

I normally have N on a wago/connection block joined with the incoming neutral and the relayed device)

I also have a 2.5 upstairs with a hue bulb on relay1, and 3x hue bathroom bulbs with extractor fan on Relay2.

That often reboots through the day, but not always when activated.

Although the extractor fan is often off via a sperate switch.

had a bit more luck with 1.11.2 i found online.

had to try a local http server with the ota url multiple times.

having the same issue a 2.5 (and same issue on 2x 1PM and 1x1).

Backup wifi is disabled.

Factory reset and still no joy.

Its running 1.94 so i cannot enable the debug log.

Tried updating it to 10.x and 11.x via a ota url and also ota url from local webserver