Beiträge von Robti

Hi can I control an RGBW2 with double and long button presses, I have a 3 position retractive momentary switch press up it switches my top RGBW2 and press down it controls my bottom rgbw2. Is there anyway to have them both switch at the same time ?

Thanks

Hi I have atm a 240v 3 position retractive wall switch to control my RGBW2 and a set of 12v light strips on top of my kitchen cabinets, now would like to add another set to the bottom of my cabinets, I was goin*to add another RGBW2 to set different colours but think this is overkill now, any comments ?

Thanks

Same position I think it’s not supported atm the long press also the same for double press for full brightness

I think I had forgotten to have a live into the switch or I made a mistake with the wiring doubling up wires into switch terminals, stripped everything back and started again using wago connector and it worked after following this

Full credit to seb briggs on AVForums

Thanks all got it in the end

Thanks for taking the time to reply, unfortunately I am stuck with the 3 position centre off retractive switches to match with all the rest of my switches, which are all set up as dual button mode, it’s just this extra switch wiring that’s throwing me. I have the live going into com and L1 going to sw1 and L2 going to sw2 and it works fine but connect the second switch up and the dimmer2 doesn’t respond to presses and gets lag when it does and then the device goes offline

Dimmer 2 wired with 3 way retractive switches, I can connect one switch and everything works but connect the second switch by connecting com-com,L1-L1 and L2-L2 and dimmer goes haywire then offline, can anyone check the wiring for us ?

Thanks