Beiträge von VMoreno

    Der Inhalt kann nicht angezeigt werden, da Sie keine Berechtigung haben, diesen Inhalt zu sehen.
    The same thing happens to me. on a 70w circuit, no problem. In this one with less than 50w of consumption, it jumps in a minute. both with Neutral connected.

    I have recalibrated, I have changed the intensity in multiples of ten ... it always jumps.

    Would the situation improve by incorporating a bypass? By quantity of consumption it does not seem necessary, but this error is terrible. And it is affecting me in the most attractive circuit of the house of some clients, I cannot fail in this matter.

    I have the same problem. with 4 LED equipments totaling 36 w. All devices are the same. After 1 minute it heats up and turns off.

    The firmware is 1.10.1, and the calibration is in "Trailing edge" mode. With the "autodetect type of load during calibration" checkbox checked.

    Thanks for your help