Beiträge von ni4ni*

Hello

I'm not sure if this is the right place to ask, but I couldn't find a more proper place, so I will just ask.

I have several Shelly 1L's that I want to flush with Tasmota. I had success with OTA flushing with one of them, but the same process bricked two others so I stopped and went the serial way.

I bought a usb to serial adapter as recommended in Tasmota website but I'm having trouble connecting it to the Shelly. I bought some pin headers like this but the distance between the holes in the Shelly 1L is smaller than the one of the pins. So I tried this but found out that the pins where too thick to fit in the holes.

Have someone here managed to buy or make a decent pin header that can connect easily into the Shelly holes without the need to oprn the case and solder things ? If yes, can you please point me to where I can get them ?

Thank you

Guy

Hello

I need to connect a shelly 1L to a two way switching light bulb (one bulb, two switches).

I saw multiple guides and youtube videos about this, but it seems like the actual wiring in my case is different. Here is a scheme of my wiring:

The only power line coming into the system is in the left switch, so I guess I should connect the Shelly there, but Im not sure how to connect the rest of the wires.

Is it possible at all (connecting the Shelly 1L and still preserving the functionality of the two physical switches) ? How do I do that ?

I already connected the bypass to the light bulb.

Thank you

Guy

Hello

I have a couple of shelly 1L's that I want to install. The problem is that I want to install them in a 2 gang switch (1 switch that controls a ceiling fan and a light separately). I successfully installed Shelly 1L in a single 1 gang switch, but I cannot figure out how to do it with the 2 gang switch. It seems like I should have one more output connector in order to do that.

The switch itself receives 1 Live wire and there are two output wires going out to the light and the fan. No neutral.

There are some online guides about 2 way switches with the Shelly 1L, but none about 2 gang switches. Is it possible at all ? if not, then which other Shelly product can be installed with w gang switch ?

Thank you

Guy

Ok, thank you.

Hello

I live in a place where the temperatures are quite high and can reach 30-35 Celsius during the day (86-95 Fharenheit).

If I look at the device temperature that the Shelly reports, it is usually around 36-39 degrees (C) when lights are off. The last couple of days where warmer and the outside temperature during the day was about 30 degrees (C).

I noticed that the Shellys reported device temperature of around 43 degrees (C) when lights are off.

This is pretty hot. What is considered normal temperature and what is considered overheating ?

Thank you

Guy