Continued from my last post where the reed was disconnected.
The uptime when the reed switch is connected and operational follows:
uptime":222700
Beiträge von Flyboy12d
VPN/Proxy erkannt
Es scheint, dass Sie einen VPN- oder Proxy-Dienst verwenden. Bitte beachten Sie, dass die Nutzung eines solchen Dienstes die Funktionalität dieser Webseite einschränken kann.
-
-
Sorry for the delay in getting back to you. I was on a different access point from the Shelly 1+ which prevented a result from the link you provided.
Here is the uptime result after keypad opening: "uptime":16063:
Appreciate you help.
-
The would not work. Any suggestions?
Thanks
Charlie
-
Appreciate your reply. I have it set to detached and have the same problem. When using keypad from gate, the reed switch operates the Shelly relay. The following are the settings.
Setup as follows:
- Using SW thru reed switch to L(-) at 24 volts DC.
- Unit powered at 24 VDC
- Using device as hidden not in a room or scene
- Reed switch is closed when gate is close
- Auto off 1.0 sec
- Input state identifier to the power button is on
- Input/Output Settings set to switch
- Relay type set to Detached
- Configured to turn off when it has power.
Thanks
-
I have a new problem with my Shelly 1 plus using the reed switch to show gate status. Shelly works well when operating using Shelly to open and close with proper status indication but when activating the gate from the gate keypad, the gate opens but is interrupted when the reed switch opens. The opening or closing of the reed switch actually activates the relay closure of I and o. I am a beginner and any help is appreciated to solve this. Thanks.
-
That Worked !…
Thank you so much….
Have a great day..
Charlie…
-
New at this:
I have installed shelly 1 plus into my gate opener and is fully operational on the app.
Problem:
The app input display setting doesn't change state via the reed switch to indicate the state of the gate by the color code, it always stays red regardless of gate position.
Setup as follows:
- Using SW thru reed switch to L(-) at 24 volts DC.
- Unit powered at 24 VDC
- Using device as hidden not in a room or scene
- Have tested the reed switch and tried manual operation to simulate reed opening and closing
- Auto off 1.0 sec
- Input state identifier to the power button is on
- Input/Output Settings set to button
- Relay type set to Detached
- Configured to turn off when it has power.
Appreciate any help in determining a solution to problem.