Beiträge von Mackensis

There I take the input phase I of the shelly on the NO output of the clock, it works which means that the clock is functional

The system itself is this, it is functional but except SW level of shelly but I take the Input phase of shelly on the NO output of the clock as in the diagram that I will follow, the clock switches the system without problem because it bypasses the SW input of Shelly

220v clock on and 120 clock off

128v with the wire disconnected from the SW and the same on SW2

Good question. When I put the multimeter in contact mode, with the clock relay off, I don't get a contact beep. If I turn the clock relay back on, I get a contact beep.
But when I put it in AC measurement mode, the multimeter shows 220V between the neutral of the 2A breaker and SW1, the clock relay on. However, I still have 115V when the clock is off.

But when I tried to put the wire back on SW1, it emitted a pulse. So a direct contact only

it still doesn't react

ok

Or this settings

C'est de cette configuration dont vous parlez?

Hello,
I'm asking for your help to get my lighting system working with Shelly remote control.
The system is controlled by a clock, which must operate at a specified time interval. The Shelly Pro module is added to the circuit to force remote activation.
To do this, the clock relay acts as a switch for the Shelly Pro1 SW input.
The circuit works remotely but doesn't turn on when the clock relay is triggered. So, I believe there's a problem with the Shelly Switch input that I'd like to resolve with you.
Thank you.