Shelly Uni - How to step up the Output 100mA to power a solenoid??

Hi,

Hoping someone with a bit of electronic knowledge can help?

I am hoping to Connect Uni to a group of water sensors that can actively switch some solenoid valves, However, the solenoids i am looking at require a 24v DC with a current of 1.0A - I assume the voltage is fine but The shelly can only output 0.1a /0.3w

Is there a device that can boost the current?

I am looking at the device below - would this work?

https://www.amazon.co.uk/ICQUANZX-High-…15724432&sr=8-3

Thanks

That's great, thanks for the info -

I am struggling to find the right relay? Are you able to suggest or advise the correct product for this?

I have a 24v Power supply ready to go

I am now looking into this Relay

https://www.amazon.co.uk/Channel-Optoco…07Q1H63D6&psc=1

It requires a signal input, would this be a DC+ signal or DC - ?

Thanks

I have drawn a quick diagram of what i assume should be right?

Attached

Does the output (Shelly +) connect to the signal input of the relay?

I assume the relay needs a trigger voltage to NO/NC - ?

Thanks