Just installed my first Shelly product.
I've wired it with no neutral.
The load is 8 finale LEDs with a rated consumption of 3.5w so total 28W which should be above the 10W minimum.
First when turning off the Shelly the LEDs are still lit, maybe 5-8%.
And when the LEDs are on they buzz insanely much. Even on 100%.
I'm running on latest firmware 1.8.5
I've run calibration.
What am I missing?
Is it set to Trailing Edge or Leading Edge? Trailing Edge is most common these days with LED loads.
And are the LED's dimmable?
Hi
@Baldag , welcome to the forum. 
If the Dimmer2 is already working and your LEDs light up, the minimum load has been met (which, by the way, in my experience is well below 10W).
The calibration should be done with trailing edge.
Do you already know our compatibility list?
Have a nice day.
