Motor shutter defect after calibration

1. offizieller Beitrag
    • Autor

    Hi,

    Today, I set up the shelly 2,5 to control my shutter. Everything was working perfect after installing. Then I hit the calibration option. The shutter went up one time, then it went down. Then it went up for 2 sec and stopped.

    Now nothing is working anymore. I see that the powerconsumption of the motor is about 148W at both relais when I toggle it.

    I had bypas the shelly to check the motor. The motor doesn't work anymore.

    What did I do wrong. ;(

    • Autor
    Zitat

    Hi mjdooren , welcome to the forum. :)

    In roller mode, there is now possbility to toggle.

    If you tested in relay mode and both switches are "on" the motor maybe defect.

    I've tested in the roller mode, everything worked well before calibration. It happened during the calibration.