Dear all,
I have 2 shelly 1 v3, flashed with ESPEasy mega-20191208.
Everything works as expected, with one exception: I don't get any readings from GPIO5. I connected L to SW input.
I tried all permutations of settings in ESPEasy, I am certain that this is not a software issue.
I tested with GPIO 1 instead, that works fine.
Any ideas or hints?
Thanks and best,
Phil
Hi, I've made the same expirience these days, on a Shelly1 v3 flashed with Tasmota v8.1.0 is the GPIO 5 not working (L to SW)
are we clueless fools? has nobody else this problem? / an solution??
Hi and welcome to the forum. 
If i understand you right, you flashed Tasmota, right?
Most of users in this forum are using the original firmware. 
I think, that's the reason, there's no answer.
Sorry, that i've no better news.
Myself, i've never used tasmota, so i coud not help too.
Estou a ter exatamente o mesmo problema, conectei primeira vez sem problema depois atualizei e nunca mais funcionou.
