reset device

LaUr3nTiU

I've switched some networks and I forgot to reset the Shelly Gas from within the web interface, and now I'm stuck since I can't figure out how to reset the shelly gas sensor. I've tried pressing the self-test button a few times, or keeping it pressed for more than 15 seconds, and it didn't go into AP mode.

There are two other "holes" on the side of the device, one which is the connector for the gas valve and another one...smaller, which might be the reset button? Can anyone instruct on how to reset the device?

kpdme

Hey here are some Guides.

Factory Reset
Hold 5 sec. press the rest button to reset WiFi to AP mode.

Hold 10 sec. press the rest button to perform a full factory reset. After a successful factory reset, the WiFi LED will blink once per second.

LaUr3nTiU

yes, but which is the reset button?

kpdme

That video will Explain How to Setup and Reset the Shelly Gas.

https://www.youtube.com/watch?v=q9J0gkeygac

tkteun

What a mess... There's an unlabeled pinhole on the side! Don't poke the sensor on the bottom

reset device

Ähnliche Themen

Shelly EM device - enables WIFI only with reset button pressed

SHelly 2.5 very very slow and unstable after update

Shelly EM - Failure AP mode after Factory Reset

There is wifi, but no cloud

This device is not currently supported - Shelly sensor as Alexa trigger