2 way switching

    Easiest and most comfortable solution might to replace the Switches by Push buttons and even better would be to use two gang Push buttons which would allow to use one pair for on/off and the second one for darker/brighter.

    Cheapest and least comfortable solution is to use the two installed switches, configuering the Dimmer in one Button mode. Then one Com Connection needs to be connected Phase (Life) wire, L1 and L2 of both switches need to be interconnected and from second Com there is a interconnection to SW1 or SW2 input of Dimmer needed.

    The SW connection, needed in one Button mode, was changed once with a firmware update, if I am right, curently SW1 has to be used.

    Einmal editiert, zuletzt von utschu (5. Juli 2021 um 19:58)

    • Autor

    Thanks for taking the time to reply, unfortunately I am stuck with the 3 position centre off retractive switches to match with all the rest of my switches, which are all set up as dual button mode, it’s just this extra switch wiring that’s throwing me. I have the live going into com and L1 going to sw1 and L2 going to sw2 and it works fine but connect the second switch up and the dimmer2 doesn’t respond to presses and gets lag when it does and then the device goes offline

    Einmal editiert, zuletzt von Robti (7. Juli 2021 um 11:06)

    Did you coonect the Live and Neutral to supply terminals as well?

    The wire landed to SW of Shelly must be from same fuse Link or breaker which is used to feed the Shelly.

  • Dieses Thema enthält 2 weitere Beiträge, die nur für registrierte Benutzer sichtbar sind.